Show simple item record

dc.contributor.authorMarios Panagiotou
dc.contributor.authorJosé I. Restrepo
dc.contributor.authorJoel P. Conte
dc.date.accessioned2017-05-08T21:59:22Z
dc.date.available2017-05-08T21:59:22Z
dc.date.copyrightJune 2011
dc.date.issued2011
dc.identifier.other%28asce%29st%2E1943-541x%2E0000373.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68232
dc.description.abstractThis paper is a companion to “Displacement-Based Method of Analysis for Regular Reinforced-Concrete Wall Buildings: Application to a Full-Scale 7-Story Building Slice Tested at UC–San Diego” and presents key results obtained from a full-scale 7-story reinforced concrete building slice built and tested on the George E. Brown Jr. Network for Earthquake Engineering Simulation Large Outdoor High-Performance Shake Table at the University of California, San Diego. The building was tested in two phases. This paper discusses the main test results obtained during Phase I of the experimental program. In this phase, the building had a rectangular load-bearing wall acting as the main lateral force–resisting element. The building was subjected to four historical California input ground motions, including the strong-intensity near-fault Sylmar record, which induced significant nonlinear response. The test addressed the dynamic response of the building, including the interaction between the walls, the slabs, and the gravity system as well as four issues relevant to construction optimization: (1) reduction in the longitudinal reinforcement; (2) use of a single curtain of reinforcement to transfer shear; (3) constrain of plasticity in the first level of the wall using capacity design; and (4) use of resistance-welded reinforcement in the boundary elements of the first level of the walls. The building responded very satisfactorily to the ground motions reproduced by the shake table and met all performance objectives. The effects of kinematic system overstrength and higher modes of response in the experimental response were important; this verified to a large extent the displacement-based method of analysis presented in the companion paper.
dc.publisherAmerican Society of Civil Engineers
dc.titleShake-Table Test of a Full-Scale 7-Story Building Slice. Phase I: Rectangular Wall
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue6
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000332
dc.treeJournal of Structural Engineering:;2011:;Volume ( 137 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record