| dc.contributor.author | Linda M. Vanevenhoven | |
| dc.contributor.author | Carol K. Shield | |
| dc.contributor.author | Lawrence C. Bank | |
| dc.date.accessioned | 2017-05-08T21:58:59Z | |
| dc.date.available | 2017-05-08T21:58:59Z | |
| dc.date.copyright | May 2010 | |
| dc.date.issued | 2010 | |
| dc.identifier.other | %28asce%29st%2E1943-541x%2E0000175.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/68016 | |
| dc.description.abstract | Fiber-reinforced polymer (FRP) pultruded profiles are produced by a number of manufacturers worldwide in similar, but nonstandard, wide-flange, I, angle, and tubular profiles. At present there is no American National Standards Institute approved design code in the United States for structural design with pultruded FRP profiles. Manufacturers of pultruded profiles each provide their own design equations, design methods, material properties, and safety factors for their pultruded products. There is a need for standardization of production and design of pultruded profiles to enable mainstream use of these profiles in structural engineering practice. The purpose of this paper is twofold: (1) to provide appropriate resistance factors ( | |
| dc.publisher | American Society of Civil Engineers | |
| dc.title | LRFD Factors for Pultruded Wide-Flange Columns | |
| dc.type | Journal Paper | |
| dc.journal.volume | 136 | |
| dc.journal.issue | 5 | |
| dc.journal.title | Journal of Structural Engineering | |
| dc.identifier.doi | 10.1061/(ASCE)ST.1943-541X.0000126 | |
| dc.tree | Journal of Structural Engineering:;2010:;Volume ( 136 ):;issue: 005 | |
| dc.contenttype | Fulltext | |