Show simple item record

dc.contributor.authorDat Duthinh
dc.contributor.authorEmil Simiu
dc.date.accessioned2017-05-08T21:58:58Z
dc.date.available2017-05-08T21:58:58Z
dc.date.copyrightMarch 2010
dc.date.issued2010
dc.identifier.other%28asce%29st%2E1943-541x%2E0000156.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68000
dc.description.abstractIn accordance with the ASCE Standard 7-05, in regions subjected to wind and earthquakes, structures are designed for loads induced by wind and, separately, by earthquakes, and the final design is based on the more demanding of these two loading conditions. Implicit in this approach is the belief that the standard assures risks of exceedance of the specified limit states that are essentially identical to the risks inherent in the provisions for regions where only wind or earthquakes occur. We draw the attention of designers, code writers, and insurers to the fact that this belief is, in general, unwarranted, and that ASCE 7 provisions are not risk consistent, i.e., in regions with significant wind and seismic hazards, risks of exceedance of limit states can be up to twice as high as those for regions where one hazard dominates. This conclusion is valid even if the limit states due to wind and earthquake are defined differently, as is the case in ASCE 7. We propose an approach to modifying ASCE 7 provisions which guarantees that risks implicit in minimum ASCE 7 requirements for regions where one hazard dominates are not exceeded for structures in regions with strong wind and seismic hazards.
dc.publisherAmerican Society of Civil Engineers
dc.titleSafety of Structures in Strong Winds and Earthquakes: Multihazard Considerations
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000108
dc.treeJournal of Structural Engineering:;2010:;Volume ( 136 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record