| dc.contributor.author | Sheng Peng | |
| dc.contributor.author | Mark L. Brusseau | |
| dc.date.accessioned | 2017-05-08T21:49:16Z | |
| dc.date.available | 2017-05-08T21:49:16Z | |
| dc.date.copyright | July 2012 | |
| dc.date.issued | 2012 | |
| dc.identifier.other | %28asce%29he%2E1943-5584%2E0000535.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/63402 | |
| dc.description.abstract | The relationship between air-water interfacial area and capillary pressure under higher water-content conditions is investigated for four natural porous media. The results show that the magnitude of the air-water interfacial area increases with increasing capillary pressure, consistent with the decrease in water saturation. The maximum observed air-water interfacial areas are dependent upon the magnitude of residual water saturation, which itself is condition-dependent. The more well-sorted porous-medium exhibited a greater rate of change of air-water interfacial area with capillary pressure than the more poorly sorted porous media. The observed relationship between air-water interfacial area and capillary pressure was quantified by coupling an empirical equation describing the air-water interfacial area versus water saturation relationship with the van Genuchten equation relating water saturation and capillary pressure. This equation produced reasonable simulations of the measured data. | |
| dc.publisher | American Society of Civil Engineers | |
| dc.title | Air-Water Interfacial Area and Capillary Pressure: Porous-Medium Texture Effects and an Empirical Function | |
| dc.type | Journal Paper | |
| dc.journal.volume | 17 | |
| dc.journal.issue | 7 | |
| dc.journal.title | Journal of Hydrologic Engineering | |
| dc.identifier.doi | 10.1061/(ASCE)HE.1943-5584.0000515 | |
| dc.tree | Journal of Hydrologic Engineering:;2012:;Volume ( 017 ):;issue: 007 | |
| dc.contenttype | Fulltext | |