Show simple item record

dc.contributor.authorAshutosh
dc.contributor.authorTrivedi
dc.date.accessioned2017-05-08T21:45:34Z
dc.date.available2017-05-08T21:45:34Z
dc.date.copyrightAugust 2013
dc.date.issued2013
dc.identifier.other%28asce%29gm%2E1943-5622%2E0000227.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/61616
dc.description.abstractThis study explores the utility of a pressure-dependent empirical hardening parameter in estimating deformation of rock masses. The hardening parameter has drawn poor attention in classical rock mechanics. Review of previous literature and observation of test results show that hardening is highly dependent on confining pressures and the plasticity already experienced, which modify joint parameters by mutual interaction. This paper provides an insight into the published test data that reflects the dependencies of the in situ deformation modulus on incremental joint parameters and the isotropic pressure ratio. There exists an empirical relation between modulus ratio and modified joint factor derived from number of joints, roughness, joint inclination, and gouge parameters. The author has interpreted the modulus ratio of jointed rock based on the modified joint factor. The author applied a hardening parameter obtained from the initial condition of stresses and that of the joint on the modified joint factor to get a modulus ratio. Using a correlation of the modified joint factor and the rock quality designation (RQD), the model successfully shows that operating hardening parameter on RQD envelops the published data of modulus ratio versus RQD. The main aim of this paper is to show that the present model is valid for in situ deformation of the strain-hardening rock mass in structural foundation, mines, and excavation design.
dc.publisherAmerican Society of Civil Engineers
dc.titleEstimating In Situ Deformation of Rock Masses Using a Hardening Parameter and RQD
dc.typeJournal Paper
dc.journal.volume13
dc.journal.issue4
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0000215
dc.treeInternational Journal of Geomechanics:;2013:;Volume ( 013 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record