Show simple item record

dc.contributor.authorManuel J. A. Leal-Gomes
dc.contributor.authorCarlos Dinis-da-Gama
dc.date.accessioned2017-05-08T21:45:17Z
dc.date.available2017-05-08T21:45:17Z
dc.date.copyrightFebruary 2011
dc.date.issued2011
dc.identifier.other%28asce%29gm%2E1943-5622%2E0000083.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/61468
dc.description.abstractThis note intends to approach the mechanical characterization of rock joints, emphasizing the application of pull tests, which are an economic and simple type of shear experiments. Explanation is given on the drawbacks resulting from the classical testing procedures which do not control the sample’s middle plane position, leading to normal scale effects (represented by negative exponential regressions), where small sample results are misleading in terms of safety. In effect, pull tests allow a very easy measurement of several joint properties, such as the so-called joint roughness coefficient, the slope of joint roughness, the roughness anisotropy, and joint strengths under low normal stresses. Some rules for their standardization are suggested by pointing out the systematic leveling of the middle joint sample plane, thus rehabilitating the interest on small samples, because of the inverse scale effects on strength that are obtained, represented by positive exponential regressions.
dc.publisherAmerican Society of Civil Engineers
dc.titleProposal for Standardization of Pull Tests on Rock Joints
dc.typeJournal Paper
dc.journal.volume11
dc.journal.issue1
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0000072
dc.treeInternational Journal of Geomechanics:;2011:;Volume ( 011 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record