Show simple item record

dc.contributor.authorFabio Minghini
dc.contributor.authorNerio Tullini
dc.contributor.authorFerdinando Laudiero
dc.date.accessioned2017-05-08T21:36:51Z
dc.date.available2017-05-08T21:36:51Z
dc.date.copyrightFebruary 2014
dc.date.issued2014
dc.identifier.other%28asce%29cc%2E1943-5614%2E0000394.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/57535
dc.description.abstractThree-point and four-point bending tests are traditionally used to estimate the shear and flexural properties of pultruded fiber-reinforced plastic (PFRP) structural shapes. In the framework of Timoshenko’s beam model, the rigidities of beams can simply be obtained from linear combinations of the experimental deflections. However, several measurement uncertainties may affect the parameter identification. To analyze this drawback, a new test configuration was compared with the common three-point and four-point bending test configurations through an extensive experimental program concerning wide-flange commercial profiles. A parametric study was conducted by varying the span length, and, in the case of the four-point bending tests, the relative position of the applied loads. The influence of the load and deflection measurement errors was analyzed and proper uncertainty bands were provided for the computed rigidities.
dc.publisherAmerican Society of Civil Engineers
dc.titleIdentification of the Short-Term Full-Section Moduli of Pultruded FRP Profiles Using Bending Tests
dc.typeJournal Paper
dc.journal.volume18
dc.journal.issue1
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)CC.1943-5614.0000391
dc.treeJournal of Composites for Construction:;2014:;Volume ( 018 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record