| dc.contributor.author | L. Ramos | |
| dc.contributor.author | N. Uddin | |
| dc.contributor.author | M. Parrish | |
| dc.date.accessioned | 2017-05-08T21:36:44Z | |
| dc.date.available | 2017-05-08T21:36:44Z | |
| dc.date.copyright | October 2013 | |
| dc.date.issued | 2013 | |
| dc.identifier.other | %28asce%29cc%2E1943-5614%2E0000368.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/57506 | |
| dc.description.abstract | Fiber-reinforced polymer (FRP) externally bonded to RC beams is commonly applied by hand layup. Vacuum-assisted resin transfer molding (VARTM), a novel application method in infrastructure, can produce FRP with more-consistent quality and uniformity. Additional steps are required, however, which can increase the application time and cost. This research will investigate the reduction of VARTM wet-out time achieved by sawing grooves into the concrete surface. Fiber-reinforced polymer U-jackets are applied by VARTM to beams with vertical grooves. The wet-out of the beams is recorded and timed. Results indicate that beams with 3.2-mm-deep grooves achieve 95% wet-out in an average of 200 s. This is only 22% of the time it takes to wet-out a beam with no grooves, an average of 911 s. A wet-out mechanism based on a modified Darcy’s law is presented to verify the results. Darcy’s law predicts that time savings increase exponentially with the length that the epoxy has to travel, which indicates that a significant amount of time could be saved on actual girders. | |
| dc.publisher | American Society of Civil Engineers | |
| dc.title | Benefits of Grooving on Vacuum-Assisted Resin Transfer Molding FRP Wet-Out of RC Beams | |
| dc.type | Journal Paper | |
| dc.journal.volume | 17 | |
| dc.journal.issue | 5 | |
| dc.journal.title | Journal of Composites for Construction | |
| dc.identifier.doi | 10.1061/(ASCE)CC.1943-5614.0000365 | |
| dc.tree | Journal of Composites for Construction:;2013:;Volume ( 017 ):;issue: 005 | |
| dc.contenttype | Fulltext | |