• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Composites for Construction
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Composites for Construction
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Reliability Assessment of FRP-Strengthened Concrete Bridge Girders in Shear

    Thumbnail
    View/Open
    %28asce%29cc%2E1943-5614%2E0000318.pdf (1.286Mb)
    Date
    2013
    Author
    Ayman M. Okeil
    Abdeldjelil Belarbi
    Daniel A. Kuchma
    Metadata
    Show full item record
    Abstract
    This paper presents the results from an investigation into the reliability of reinforced concrete bridge girders strengthened in shear using fiber-reinforced polymers (FRP). Two expressions for the shear design of FRP-strengthened girders were developed as part of a National Cooperative Highway Research Program project. The expressions were developed for two distinct cases, namely, bonded and anchored FRP reinforcement. Uncertainties inherent in the new design models were first assessed using an extensive database of hundreds of experimentally tested specimens. Variabilities in material, fabrication tolerances, dead and live loads, and distribution factors obtained from the literature were then included in a limit state function for the shear strength mode of failure. The reliability of a representative design space comprising 18 bridge girders that cover different span lengths, shear deficiency levels, and girder location (exterior versus interior) was calculated for both bonded and anchored strengthening techniques. The use of approximate expressions for reliability index calculations was deemed unacceptable because of the high scatter in the results. This paper discusses the difference between two reliability methods [Monte Carlo simulations and first-order reliability method (FORM)] that were first used to ensure the validity of FORM in analyzing the developed limit state function. The results showed that the new design expressions result in reliability index values in the range targeted by most design codes (3.00–3.50), albeit lower than the target value used in the calibration of AASHTO load and resistance factor design (LRFD) (
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/57452
    Collections
    • Journal of Composites for Construction

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV