• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Composites for Construction
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Composites for Construction
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Performance of Glued-Laminated Timbers with FRP Shear and Flexural Reinforcement

    Thumbnail
    View/Open
    %28asce%29cc%2E1943-5614%2E0000209.pdf (1.558Mb)
    Date
    2011
    Author
    T. Russell Gentry
    Metadata
    Show full item record
    Abstract
    Glued-laminated wood beams (glulams) have low allowable shear stresses relative to competitive engineering wood products such as parallel strand lumber and laminated veneer lumber. For heavily loaded applications such as garage door headers, the lower shear allowable stresses typically necessitate the use of larger glulam members relative to other engineered lumber. This paper reports on experimental research aimed at increasing the shear capacity of glulams. To increase the shear strength, a series of fiber-reinforced polymeric (FRP) pins are inserted into holes drilled transversely across the plies of the glulam. These pins are epoxy-bonded into place after the glulam has been produced. The test results show that the shear strength scatter in the pinned set of glulams is significantly reduced as compared to the unpinned specimens. Two- and three-parameter Weibull estimates of the service-level allowables increases between 40% and 100% for specimen sets reinforced by the FRP pins. The transverse reinforcing scheme also shows promise for aiding in engagement of composite flexural reinforcement plies into the laminate stack. Previous research has shown that the bonding between wood and FRP plies has potential long-term durability problems. Therefore, the pinning technology reported on in this work shows promise for providing a means for direct engagement (through bearing of the pins) of the FRP plies to the wood plies. This behavior has been demonstrated though the testing of larger-scale specimens with both transverse shear reinforcements and longitudinal FRP plies. The reinforcing strategies show potential structural and economic advantages, especially when the FRP is coupled with low-grade, low-value finger-jointed lumber.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/57332
    Collections
    • Journal of Composites for Construction

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV