Show simple item record

dc.contributor.authorD. A. Bournas
dc.contributor.authorT. C. Triantafillou
dc.contributor.authorK. Zygouris
dc.contributor.authorF. Stavropoulos
dc.date.accessioned2017-05-08T21:36:03Z
dc.date.available2017-05-08T21:36:03Z
dc.date.copyrightOctober 2009
dc.date.issued2009
dc.identifier.other%28asce%29cc%2E1943-5614%2E0000031.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/57140
dc.description.abstractThe effectiveness of a new structural material, namely, textile-reinforced mortar (TRM), was investigated experimentally in this study as a means of confining oldtype reinforced concrete (RC) columns with limited capacity due to bar buckling or due to bond failure at lap splice regions. Comparisons with equal stiffness and strength fiber-reinforced polymer (FRP) jackets allow for the evaluation of the effectiveness of TRM versus FRP. Tests were carried out on nearly full scale nonseismically detailed RC columns subjected to cyclic uniaxial flexure under constant axial load. Ten cantilevertype specimens with either continuous or lap-spliced deformed longitudinal reinforcement at the floor level were constructed and tested. Experimental results indicated that TRM jacketing is quite effective as a means of increasing the cyclic deformation capacity of oldtype RC columns with poor detailing, by delaying bar buckling and by preventing splitting bond failures in columns with lap-spliced bars. Compared with their FRP counterparts, the TRM jackets used in this study were found to be equally effective in terms of increasing both the strength and deformation capacity of the retrofitted columns. From the response of specimens tested in this study, it can be concluded that TRM jacketing is an extremely promising solution for the confinement of reinforced concrete columns, including poorly detailed ones with or without lap splices in seismic regions.
dc.publisherAmerican Society of Civil Engineers
dc.titleTextile-Reinforced Mortar versus FRP Jacketing in Seismic Retrofitting of RC Columns with Continuous or Lap-Spliced Deformed Bars
dc.typeJournal Paper
dc.journal.volume13
dc.journal.issue5
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)CC.1943-5614.0000028
dc.treeJournal of Composites for Construction:;2009:;Volume ( 013 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record