Show simple item record

dc.contributor.authorGhatu Subhash
dc.contributor.authorStanley J. Vitton
dc.contributor.authorHuang Chengyi
dc.date.accessioned2017-05-08T21:32:05Z
dc.date.available2017-05-08T21:32:05Z
dc.date.copyrightJanuary 2008
dc.date.issued2008
dc.identifier.other%28asce%291532-3641%282008%298%3A1%2882%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/55145
dc.description.abstractThe static and dynamic uniaxial compressive strengths of coarse aggregate materials used in portland cement concrete (PCC) were determined under dry and saturated conditions for three blast furnace slags, three limestones, four dolomites, and two mafic igneous rocks. The slag aggregates exhibited the lowest compressive strength, followed by the carbonates (limestones and dolomites), and the mafic igneous rocks. Both the dry and saturated aggregates revealed a higher compressive strength under dynamic loads compared to the static loads. Based on the experimental data, a rate sensitivity parameter was defined to describe the increase in compressive strength as a function of strain rate. This parameter is deemed to have considerable relevance in evaluating the ability of a specific aggregate to resist dynamic loads such as in aggregate interlock in PCC cracks and joints, friction in asphalt, and also in the development of microfracture during rock blasting. Comparison of the compressive strength data to density and LA abrasion values revealed that the dynamic data have a better correlation to the above properties than the static data.
dc.publisherAmerican Society of Civil Engineers
dc.titleDynamic Fracture and Strain Rate Behavior of Aggregates Used in Transportation
dc.typeJournal Paper
dc.journal.volume8
dc.journal.issue1
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)1532-3641(2008)8:1(82)
dc.treeInternational Journal of Geomechanics:;2008:;Volume ( 008 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record