Show simple item record

dc.contributor.authorAnnamaria Cividini
dc.contributor.authorGiancarlo Gioda
dc.date.accessioned2017-05-08T21:32:03Z
dc.date.available2017-05-08T21:32:03Z
dc.date.copyrightSeptember 2007
dc.date.issued2007
dc.identifier.other%28asce%291532-3641%282007%297%3A5%28325%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/55119
dc.description.abstractThe geotechnical design of drainage or dewatering systems requires a free surface seepage analysis to evaluate the water flux that corresponds to the sought lowering of the water table. It is observed in practice that sometimes the calculated flux is not sufficient to reach the predicted result, even when the hydraulic conductivity of the soil mass has been properly determined. This prevents the initiation of the in situ works (e.g., excavation) with a relevant economical loss. The possible causes of this problem are investigated through a series of two- and three-dimensional unconfined seepage analyses. They show that the numerical results strongly depend on the characteristics of the numerical model and that, consequently, the computed fluxes and lowering of the water table do not necessarily correspond to the field conditions. To overcome this drawback a back-analysis approach is suggested for calibrating the numerical model adopted in design. An application of this technique to an actual field problem is finally discussed.
dc.publisherAmerican Society of Civil Engineers
dc.titleBack-Analysis Approach for the Design of Drainage Systems
dc.typeJournal Paper
dc.journal.volume7
dc.journal.issue5
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)1532-3641(2007)7:5(325)
dc.treeInternational Journal of Geomechanics:;2007:;Volume ( 007 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record