Show simple item record

dc.contributor.authorTanit Chalermyanont
dc.contributor.authorCraig H. Benson
dc.date.accessioned2017-05-08T21:31:50Z
dc.date.available2017-05-08T21:31:50Z
dc.date.copyrightSeptember 2005
dc.date.issued2005
dc.identifier.other%28asce%291532-3641%282005%295%3A3%28196%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/55011
dc.description.abstractA two-phase approach was used to develop a reliability-based design (RBD) method for external stability of mechanically stabilized earth (MSE) walls. In the first phase, a parametric study was conducted using Monte Carlo simulation to identify parameters that affect the probability of external failure of MSE walls. Three modes of failure were considered: sliding, overturning, and bearing capacity. External stability was assessed by treating the reinforced soil as a rigid mass using the same procedures employed for conventional gravity-type wall systems. Results from the parametric study indicate that the mean and coefficient of variation of the backfill friction angle are significant for sliding, the mean and coefficient of variation of the friction angle of the backfill and coefficient of variation of the unit weight of the backfill are significant for overturning, and the mean and coefficient of variation of the friction angle of the foundation soil and the mean of the backfill friction angle are significant for bearing capacity. In the second phase, a series of additional simulations was conducted where the significant parameters identified in the parametric study were varied over a broad range. Results of these simulations were used to develop a set of RBD charts for external stability of MSE walls. A comparison indicates that similar reinforcement lengths are obtained using RBD and conventional methods and that the inherent probability of external failure in conventional deterministic design is
dc.publisherAmerican Society of Civil Engineers
dc.titleReliability-Based Design for External Stability of Mechanically Stabilized Earth Walls
dc.typeJournal Paper
dc.journal.volume5
dc.journal.issue3
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)1532-3641(2005)5:3(196)
dc.treeInternational Journal of Geomechanics:;2005:;Volume ( 005 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record