Show simple item record

dc.contributor.authorT. M. Roberts
dc.date.accessioned2017-05-08T21:30:32Z
dc.date.available2017-05-08T21:30:32Z
dc.date.copyrightNovember 2002
dc.date.issued2002
dc.identifier.other%28asce%291090-0268%282002%296%3A4%28241%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/54155
dc.description.abstractTheoretical studies of the influence of shear deformation on the flexural, torsional, and lateral buckling of pultruded fiber reinforced plastic (FRP)-I-profiles are presented. Theoretical developments are based on the governing energy equations and full section member properties. The solution for flexural buckling is consistent with the established solution based on the governing differential equation. The new solutions for torsional and lateral buckling incorporate a reduction factor similar to that for flexural buckling. The solution for lateral buckling also incorporates the influence of prebuckling displacements. Closed form solutions for a series of simply supported, pultruded FRP I-profiles, based on experimentally determined full section flexural and torsional properties, indicate the following conclusions. For members subjected to axial compression, shear deformation can reduce the elastic flexural and torsional buckling loads by up to approximately 15% and 10%, respectively. For members subjected to bending, prebuckling displacements can increase the buckling moments by over 20% while shear deformation decreases the buckling moments by less than 5%.
dc.publisherAmerican Society of Civil Engineers
dc.titleInfluence of Shear Deformation on Buckling of Pultruded Fiber Reinforced Plastic Profiles
dc.typeJournal Paper
dc.journal.volume6
dc.journal.issue4
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)1090-0268(2002)6:4(241)
dc.treeJournal of Composites for Construction:;2002:;Volume ( 006 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record