Show simple item record

dc.contributor.authorAmnon Katz
dc.date.accessioned2017-05-08T21:30:24Z
dc.date.available2017-05-08T21:30:24Z
dc.date.copyrightAugust 2000
dc.date.issued2000
dc.identifier.other%28asce%291090-0268%282000%294%3A3%28137%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/54066
dc.description.abstractThe bond mechanism of fiber-reinforced polymer (FRP) rebars to concrete was studied to evaluate the effect of cyclic loading. Five different types of 12.0- and 12.7-mm rebars were tested. The FRP rods were embedded in concrete blocks and were subjected to up to 450,000 cycles at service stress level. The loading was accompanied by immersion in water at 60 and 20°C to accelerate deterioration effects. Pullout behavior of the rods was determined at the end of the loading period. The results indicated a reduction in the bond strength after loading. Three mechanisms of failure were identified: (1) Abrasion of the surface of the rod, which, in the case of uniform resin throughout the rod, may lead to a reduction of 20–30% in the bond strength; (2) delamination of the outer layer of the resin at the surface of the rod, which may lead to a reduction of up to 60% in the bond strength; and (3) abrasion of cement particles entrapped between the rod and the concrete, which serves as the main source of “bond” for smooth rods leading to approximately 70% of reduction in the bond strength. There was no significant change in the effect of curing temperature on the loss of bond.
dc.publisherAmerican Society of Civil Engineers
dc.titleBond to Concrete of FRP Rebars after Cyclic Loading
dc.typeJournal Paper
dc.journal.volume4
dc.journal.issue3
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)1090-0268(2000)4:3(137)
dc.treeJournal of Composites for Construction:;2000:;Volume ( 004 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record