Show simple item record

dc.contributor.authorEver J. Barbero
dc.contributor.authorLiliana DeVivo
dc.date.accessioned2017-05-08T21:30:22Z
dc.date.available2017-05-08T21:30:22Z
dc.date.copyrightNovember 1999
dc.date.issued1999
dc.identifier.other%28asce%291090-0268%281999%293%3A4%28185%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/54044
dc.description.abstractA simple procedure is developed for the selection of pultruded structural shapes to be used as beam-columns in structural design. The design equations are then validated by comparison with experimental data gathered during beam-column testing of wide-flange and I-beam pultruded structural shapes. The design procedure accounts for axial load eccentricity and bending action induced by lateral loads and end-moments. The design equations are set in the context of load and resistance factor design, considering both strength and serviceability. This paper addresses the methodology to determine the resistance factors, which should be used with properly selected load-factors accounting for the variability and uncertainty of the loads. The design equations use section-properties, such as the bending stiffness (
dc.publisherAmerican Society of Civil Engineers
dc.titleBeam-Column Design Equations for Wide-Flange Pultruded Structural Shapes
dc.typeJournal Paper
dc.journal.volume3
dc.journal.issue4
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)1090-0268(1999)3:4(185)
dc.treeJournal of Composites for Construction:;1999:;Volume ( 003 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record