Comparison of Prestress Losses for a Prestress Concrete Bridge Made with High-Performance Concrete

Abstract

Five prestressed concrete girders made with high-performance concrete were instrumented using vibrating-wire strain gages. Their behavior was monitored for three years from the time of casting. The measured change in concrete strain at the centroid of the prestressing strands was used to evaluate changes in prestress. The total measured prestress loss was as large as 28% of the total jacking stress. Due to the higher stresses, this loss is larger than would be expected for a girder made with conventional-strength concrete. The observed values of prestress losses were compared with values calculated using the recommended AASHTO LRFD and NCHRP 18-07 procedures. The AASHTO LRFD method overpredicted the average prestress losses for the highly stressed Span 2 girders by 20% while the NCHRP method underpredicted the average losses by 16%. The NCHRP method was found to be more inclusive and adaptable to regional construction. The calculated NCHRP Span 2 losses were found to be within 10% of the average measured losses when the elastic shortening losses were calculated based on measured data and differential shrinkage was calculated based on continuous beams.