Show simple item record

dc.contributor.authorEileen P. Poeter
dc.contributor.authorJohn E. McCray
dc.date.accessioned2017-05-08T21:24:23Z
dc.date.available2017-05-08T21:24:23Z
dc.date.copyrightAugust 2008
dc.date.issued2008
dc.identifier.other%28asce%291084-0699%282008%2913%3A8%28702%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/50235
dc.description.abstractWater table mounding warrants consideration in the design of cluster and high-density wastewater soil absorption systems (WSAS). Use of iterative analytical solutions with the design approach presented here provides a useful initial assessment of the potential for mounding beneath a WSAS, but cannot account for anisotropy, heterogeneity, regional flow, and local hydraulic boundaries. The relative influence of these factors may not be intuitive, but can be evaluated with site-specific numerical models in cases where the failure of these systems may have severe consequences. There is a greater difference of calculated mound height for isotropic analytical solutions and anisotropic numerical solutions in low hydraulic conductivity materials and thicker aquifers. In all cases, increased vertical anisotropy increases mounding, but not nearly as much as would be calculated by using the vertical hydraulic conductivity value for hydraulic conductivity in the analytical solution. Increased gradient has less influence on mound height in thicker aquifers.
dc.publisherAmerican Society of Civil Engineers
dc.titleModeling Water Table Mounding to Design Cluster and High-Density Wastewater Soil Absorption Systems
dc.typeJournal Paper
dc.journal.volume13
dc.journal.issue8
dc.journal.titleJournal of Hydrologic Engineering
dc.identifier.doi10.1061/(ASCE)1084-0699(2008)13:8(702)
dc.treeJournal of Hydrologic Engineering:;2008:;Volume ( 013 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record