| dc.description.abstract | One of the most promising additive manufacturing technologies for the production of end-use parts is powder bed fusion of polymer with laser beam (PBF-LB/P). This technology can reduce production costs by increasing process efficiency and production speed. As PBF-LB/P is a layer-wise additive manufacturing process, the production speed can be increased by reducing the layering time. Although some operations such as recoating are performed during the layering process, considerable time is spent on laser scanning. To reduce the laser exposure time while maintaining proper powder melting, a high-power beam should be irradiated to the powder layer to prevent energy shortage. However, as the laser beam power increases, the irradiance at the beam center increases significantly, causing powder degradation such as thermal decomposition or sublimation. In this study, an appropriate input energy range was determined by obtaining an input energy limit that does not cause powder deterioration via experimental observations and temperature estimations during the process. Furthermore, the influence of the scanning parameters on the mechanical properties of built specimens was investigated to reduce the layering time within an indicated range. Results show that the mechanical strength of the built parts decreases slightly as the scan spacing increases following the expansion of the beam diameter. This study also validated the effects of scanning parameters on layering time. As a result, by doubling the scan speed and spacing, the layering time can be reduced by up to 1/3. | |
