Validation of a Methodology to Assess the Flutter Limit-Cycle Oscillation Amplitude of Low-Pressure Turbine Bladed Disks—Part I: Mach Number Effects

Abstract

This paper presents a methodology to estimate the vibration amplitude of fluttering low-pressure turbine (LPT) blades saturated due to friction effects. The study utilizes an analytical model that balances aerodynamic work and dry-friction work. The analytical predictions are compared against experimental results to validate the model. The first part of this paper focuses on the influence of the Mach number on the work balance between aerodynamic and mechanical components. It is observed that the vibration amplitude of low-pressure turbine rotor blades notably increases with higher Mach numbers. In addition, numerical simulations are employed to assess the influence of the Mach number on the critical damping ratio. The results demonstrate that an appropriate scaling of the critical damping ratio with the exit Mach number collapses all the damping versus interblade phase angle curves into a single curve. This finding validates the scaling of the aerodynamic damping for different pressure ratios. Unsteady pressure measurements were acquired, carefully postprocessed to extract their flutter-induced peak components, and presented in a nodal diameter (ND) by nodal diameter basis. The postprocessed data were then used to characterize the vibration amplitude observed in the experiments. The trends of the measured unsteady pressure on the casing of a rotating rig and the proposed model with the Mach number for different shaft speeds are in good agreement. The vibration amplitude and the mean unsteady pressure increase with the Mach number and exhibit a maximum with the shaft speed.