Heat Transfer Coefficient and Adiabatic Effectiveness Measurements on a Nozzle Guide Vane With a Single Row of Cylindrical Holes

Abstract

Film-cooling injection significantly affects the thermal behavior of turbine vane surfaces. In addition to the beneficial effect of the film shielding the vane from the hot gas flow, alteration of the thermal boundary layer should also be taken into account. The aim of the present work is to detail the film-cooling performance in terms of adiabatic effectiveness and external heat transfer coefficient on a 2D nozzle guide vane. A single row of cylindrical holes was tested on both pressure and suction sides of a literature vane, the VKI LS89, in a linear cascade. The employed measurement technique is a transient thermal method based on infrared thermography, which was thoroughly described and validated in a previous work. The influence of inlet freestream turbulence and blowing ratio was evaluated, and two different injection angles were considered for both pressure and suction sides. Spatially resolved distributions of adiabatic effectiveness and heat transfer coefficient (HTC) on the vane surface allow us to precisely quantify the above-mentioned aspects and highlight qualitative differences between pressure side and suction side behavior. Details regarding the generated non-uniformities in the measured parameters could be also provided, to emphasize how average quantities are not always sufficient to characterize such complex phenomena. The impact of different reference conditions to scale HTC results was also investigated. Such effect was found not negligible on the overall performance of the film-cooling system, especially on the suction side where transition plays a critical role. Ultimately, the collected results constitute a wide and detailed experimental database for numerical modeling validation in a well-studied environment as the LS89 configuration.