Evaluation of the Performance of Micro–Nano Bubbles to Control the Simultaneous Inorganic and Colloidal Foulings in Reverse Osmosis

Abstract

The coexistence of different foulant compositions in the feed water of reverse osmosis (RO) systems causes serious complications in the fouling process of the membranes. Hence, in this technical research, the phenomenon of combined inorganic (gypsum)-colloidal (silica particles) fouling (inorganic-colloidal fouling) of brackish water RO (BWRO) process was studied in the lab-scale experiments. Moreover, the effect of the presence of air micro–nano bubbles (AMNBs) in the feed water; as a new practical method for control of membrane fouling, was investigated on this phenomenon. For this purpose, a suspension with the potential of inorganic scaling [calcium sulfate, Saturation index (SI)=0.96] and colloidal fouling (colloidal silica, 50 mg/L) was used to form the inorganic and colloidal foulings (simultaneously) on the membrane surface during the inorganic-colloidal fouling process. All experiments were performed twice, once in the absence and once in the presence of AMNBs. Finally, the results of this research were compared with the results of the inorganic and colloidal fouling studies. Based on the results, the inorganic-colloidal fouling formed a dense and compact fouling layer on the membrane surface, which severely reduced the permeate flux (76.3%) and salt rejection (4%). The amount of decrease of these two parameters in inorganic-colloidal fouling was much higher than each of individual inorganic and colloidal foulings. In the presence of AMNBs, both types of inorganic and colloidal foulings greatly reduced and the major portion of inorganic-colloidal fouling was related to the colloidal fouling. Thus, a significant decline was observed in adverse effects of inorganic-colloidal fouling on the membrane performance and the permeate flux and salt rejection decreased by 18.5% and about 1%, respectively. The results of this study could introduce the micro–nano bubbles (MNBs) technology as an effective method to inhibit the inorganic-colloidal fouling in RO systems. Today, reverse osmosis processes are known as efficient technologies for supplying drinking water from brackish and sea water resources due to their high ability to remove various compounds. The separated compounds from the water accumulate near the membrane surface and consequently deposit on it and/or inside its pores. This phenomenon is called membrane fouling and has adverse effects on the performance of reverse osmosis processes. Water resources usually have different types of pollutants that simultaneous presence of them can intensify the membrane fouling process. Gypsum scaling and colloidal silica fouling are two major common types of reverse osmosis membrane fouling. Therefore, in this research, the effects of the inorganic-colloidal fouling were studied on the performance of a commercial brackish water reverse osmosis membrane, in presence and absence of air micro–nano bubbles. The results showed that the combined fouling formed a complex fouling layer on the membrane surface in absence of air micro–nano bubbles. In real-scale reverse osmosis process, this layer can severely reduce the membrane permeate flux and salt rejection which result to increase in the operational and maintenance costs. Alternatively, the presence of air micro–nano bubbles in the reverse osmosis feed flow could limit both inorganic and colloidal foulings and their synergetic effects on each other.