• Login
    View Item 
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Stability Assessment of Bolt-Supported Road Cutting Dip Slopes Using Discrete-Element and Limit-Analysis Methods

    Thumbnail
    View/Open
    10.1061-IJGNAI.GMENG-9027.pdf (3.111Mb)
    Date
    2024/04/01
    Author
    Chaoyi Sun
    Congxin Chen
    Caihua Liu
    Jiahao Yuan
    Yun Zheng
    Metadata
    Show full item record
    Abstract
    Fully grouted bolts are widely used to reinforce road cutting slopes because of their low cost and high efficiency. However, there is a lack of research on the anchorage failure mechanism and stability assessment of bolt-supported road cutting dip slopes (BRCDSs). In this work, a progressive failure process of BRCDSs was captured via a triangular block model in the Universal Distinct Element Code (UDEC). A kinematically admissible velocity field of BRCDSs was innovatively established based on their sliding shear failure and the Mohr–Coulomb criterion. As a consequence, a novel method for evaluating the stability of BRCDSs was proposed using the upper bound theorem of limit analysis. The reinforcement effects of BRCDSs with different bolt angles were subsequently evaluated by UDEC simulations, and the obtained slope safety factors and bolt-supporting forces were compared with the results calculated by the proposed method. In addition, the influence of various parameters (bolt angle, bolt diameter, slope angle, and strengths of rock and discontinuity) on the reinforcement effect was investigated. The results obtained using the proposed method showed good agreement with those obtained via UDEC. There is an optimal bolt angle in BRCDSs, at which the bolt generates the largest supporting force and thus promotes the highest safety factor of the slope, and the value of this angle is approximated as the friction angle of the discontinuity. The safety factor of the slope also increases with the increase of bolt diameter, and the variation increasing according to a power function. The method proposed provided a convenient theoretical tool for the stability assessment and reinforcement design of BRCDSs.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4297002
    Collections
    • International Journal of Geomechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV