• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Pipeline Systems Engineering and Practice
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Pipeline Systems Engineering and Practice
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Numerical Simulation of Multiphase Flow Erosion in the Gas Well Relief Line Elbow under Supercritical Conditions

    Thumbnail
    View/Open
    JPSEA2.PSENG-1457.pdf (5.503Mb)
    Date
    7/7/2023 1
    2023-07-07
    Author
    Jiajia Jing
    Liuchuan Yang
    Xi Tang
    Ping He
    Kai Tang
    Metadata
    Show full item record
    Abstract
    The erosion of a gas well relief line elbow under supercritical conditions must be investigated, because under these conditions, it may be pierced within a few minutes, which may significantly affect control safety and cause casualties and environmental pollution. Herein, the Eulerian-Lagrangian method was used to establish a numerical model to examine a gas well relief line elbow erosion under supercritical conditions. The numerical model was verified by combining the unit erosion experiments and field failure cases. On this basis, we conducted a simulation analysis of elbow erosion under supercritical conditions according to actual blowout conditions. Nine influencing factors, including the angle of the elbow and discharge volume, were considered. The erosion mechanisms and laws of the elbow under gas–solid two-phase flow, liquid–solid two-phase flow, and gas–liquid–solid three-phase flow were also determined. The erosion laws of the elbow under gas–solid and gas–liquid–solid flow conditions were similar, with severe erosion occurring in the extrados of the elbow. The maximum erosion rate increases with increasing sand content, particle shape coefficient, and temperature, and it decreases with increasing outlet length. Moreover, the maximum erosion rate first increases and then decreases with increasing particle size before finally stabilizing with increasing discharge amount. The erosion rate of the gas–solid flow first increases and then decreases with increasing elbow angle. In contrast, severe erosion occurs on the side wall of the bend for liquid–solid flow conditions. The maximum erosion rate increases with increasing velocity and sand content and decreases with increasing elbow angle and particle shape coefficient. Moreover, it first decreases and then increases with increasing particle size, and it is barely affected by the outlet length and temperature. This study provides key theoretical support for elbow selection and structural optimization.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4294088
    Collections
    • Journal of Pipeline Systems Engineering and Practice

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV