| dc.description.abstract | In practical engineering, it is common to offset the drainage system axis to avoid conflicts with beams and columns. However, such an offset could significantly affect the system’s discharge capacity and drainage safety, leading to a prominent positive pressure above the offset floor. To address this issue, we propose optimizing the system by changing the elbow shapes at the offset position. In our study, we conducted comparative experiments on three elbow shapes, namely, a normal 90° elbow, double 45° elbow, and large curvature elbow, in two experimental systems. Pressure fluctuation and water seal losses were used as experimental parameters to determine the maximum discharge capacity in accordance with the Standard for Capacity Test of Vertical Pipe of the Domestic Residential Drainage System. Our experimental results show that replacing the 90° elbow with the double 45° elbow slightly reduces positive pressure. On the other hand, using the large curvature elbow effectively increases the drainage flow and reduces the positive pressure caused by the upper floor bias. Furthermore, we employed computational fluid dynamics (CFD) software to simulate the flow of water and air in the system, demonstrating the benefits of increasing the elbow at the connecting position. | |
