Show simple item record

dc.contributor.authorMostafa Asadizadeh
dc.contributor.authorMahdi Moosavi
dc.contributor.authorMohammad Farouq Hossaini
dc.contributor.authorAhmadreza Hedayat
dc.contributor.authorTaghi Sherizadeh
dc.contributor.authorHossein Masoumi
dc.date.accessioned2023-11-27T23:21:53Z
dc.date.available2023-11-27T23:21:53Z
dc.date.issued7/1/2023 12:00:00 AM
dc.date.issued2023-07-01
dc.identifier.otherIJGNAI.GMENG-7858.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4293501
dc.description.abstractCharacterizing the mechanical behavior of jointed rocks is important to understand the behavior of structures in rock masses. Jointed rocks can be composed of persistent and nonpersistent joints where the impact of nonpersistent joints requires careful consideration for an accurate rock mass mechanical characterization. Most previous investigations into nonpersistent jointed rocks focused on joints with smooth surfaces, and a few experimental studies focused on nonpersistent rough joints and nothing specific has been reported numerically. Therefore, this study investigated several synthetic jointed rocks with nonpersistent rough joints numerically under uniaxial compressive and shear loadings. The PFC2D-based synthetic rock mass (SRM) approach was adopted to assess the impact of bridge angle (γ) and length (L), joint roughness coefficient (JRC), and normal stress (σn) on the shear strength (τn) and cracking in jointed rocks with nonpersistent rough joints. In addition, the impacts of γ, L, JRC, and joint inclination (θ) on the uniaxial compressive strength (UCS or σcm), elastic modulus (Em), and failure pattern in the jointed blocks were examined numerically. First, several numerical models were developed and verified by the laboratory data, followed by an extensive parametric study to assess the effects of the defined parameters further. The effects of JRC and σn on τn were more pronounced than γ and L due to the formation of interlocking cracks, which could cause significant shear resistance during shear loading. In addition, the numerical results under axial loading revealed that an increase in θ could reduce the deformation modulus and the value of the other parameters, in particular the JRC, could lead to an increase in the strength of jointed samples.
dc.publisherASCE
dc.titleNumerical Modeling of Rock Blocks with Nonpersistent Rough Joints Subjected to Uniaxial Compressive and Shear Loadings
dc.typeJournal Article
dc.journal.volume23
dc.journal.issue7
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/IJGNAI.GMENG-7858
dc.journal.fristpage04023103-1
dc.journal.lastpage04023103-26
dc.page26
dc.treeInternational Journal of Geomechanics:;2023:;Volume ( 023 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record