Show simple item record

dc.contributor.authorLin, Lingnan
dc.contributor.authorKedzierski, Mark A.
dc.date.accessioned2023-08-16T18:27:13Z
dc.date.available2023-08-16T18:27:13Z
dc.date.copyright2/21/2023 12:00:00 AM
dc.date.issued2023
dc.identifier.issn2832-8450
dc.identifier.otherht_145_07_071601.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4291981
dc.description.abstractRecent studies report an anomalous phenomenon, particularly for small diameter microfin tubes, where the flow boiling heat transfer coefficient decreases with increasing mass velocity in the convective regime, which is contrary to that found for smooth tubes and larger diameter microfin tubes. This paper presents a critical literature review and mechanistic analysis of the anomalous phenomenon. Our analysis suggests that the anomalous phenomenon is a result of the transition of annular flow pattern from “flooded-groove” (film thickness > fin height) to “in-groove” (film thickness < fin height). The latter is associated with lower degree of turbulence, smaller wetted area, and therefore smaller heat transfer coefficient than the former. We speculated that the in-groove annular flow only occurs for small diameter tubes where the liquid film is relatively uniform, while larger tubes tend to remain flooded at the tube-bottom until dryout. This may explain the tendency of the anomalous phenomenon to occur in small diameter tubes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnomalous Adverse Effect of Mass Velocity on Convective Flow Boiling in Small-Diameter Microfin Tubes
dc.typeJournal Paper
dc.journal.volume145
dc.journal.issue7
dc.journal.titleASME Journal of Heat and Mass Transfer
dc.identifier.doi10.1115/1.4056569
dc.journal.fristpage71601-1
dc.journal.lastpage71601-9
dc.page9
dc.treeASME Journal of Heat and Mass Transfer:;2023:;volume( 145 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record