Drag Reduction for Flow Past Circular Cylinder Using Static Extended Trailing Edge

Abstract

A numerical study has been carried out on the two-dimensional flow past a circular cylinder. In this case, a splitter plate is provided at the rear stagnation point in the downstream direction. ansys fluent has been used to carry out the numerical simulations based on finite volume method approach. Grid independence was achieved and the numerical model was validated with results available in open literature at Reynolds numbers of 100, 5000, and 100,000 respectively. In the present investigation, the characteristics of vortex shedding due to the presence of splitter plate in the circular cylinder were investigated. The main focus of this research was to find the optimal splitter plate length for low, moderate, and high Reynolds numbers. It was observed that at low, moderate, and high Reynolds numbers, the drag coefficient (cd) for optimal plate length decreased drastically as compared to the baseline circular cylinder case. Moreover, the fluctuating nature of lift coefficient (cl) had also ceased. This research work has a good potential to decrease time-varying structural loads on bluff bodies by decreasing the vortex shedding frequency and consequently decreasing drag. The scope of our research extends to structures of bridges and large vehicles, radiator pipes of heat exchangers, landing gears of aircraft, and many more.