Show simple item record

dc.contributor.authorXiaopeng Su
dc.contributor.authorHonglian Li
dc.contributor.authorJialiang Liu
dc.contributor.authorZhonghui Shen
dc.contributor.authorXiangyan Ren
dc.contributor.authorLei Zhou
dc.date.accessioned2023-04-07T00:29:57Z
dc.date.available2023-04-07T00:29:57Z
dc.date.issued2022/12/01
dc.identifier.other%28ASCE%29GM.1943-5622.0002606.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4289150
dc.description.abstractWater flow experiments in single tensile and shear granite fractures were conducted to investigate the nonlinear flow behavior. Fracture geometry parameters based on single fracture wall (Rp, Z2, Z3, Z4, JRC) and two fracture walls (aperture distribution, cluster coefficient) were calculated and compared. The effect of these fracture geometry characteristics on nonlinear flow behavior was explored. Fracture transmissivity, critical Reynolds number, pressure gradient, and normalized transmissivity were analyzed in detail. The result shows that shear fracture geometry has the characteristics of higher mean aperture with higher standard deviation, more clustering contact, and rougher fracture surface. The shear to tensile fracture transmissivity ratio increases from 2.3 to around 370 with the increase of confining pressure from 2 to 60 MPa and the stress-dependence coefficient of shear fractures is close to 1/22 of tensile fractures. The critical pressure gradient increases as confining pressure, indicating that it requires a higher pressure gradient to drive the linear flow to nonlinear flow, namely, when the injection pressure gradient keeps unchanged, high confining pressure causes the nonlinear flow to turn to linear flow. The critical gradient of the shear fracture is 0.004–0.527 MPa/m on average, which is much lower than that of tensile fractures (0.011–26.862 MPa/m), meaning that a lower pressure gradient can drive the linear flow to nonlinear flow in a shear fracture. The average Forchheimer coefficient β for tensile fractures is 0.133, which is about half of the shear fracture (0.253). Regression analysis indicates that a linear relationship exists between β and the fracture geometry parameters (mean aperture η and cluster coefficient ς) and the correlation coefficient is about 0.925 and 0.920, respectively. Further investigation confirms the “weak inertial effect” with the (T0/T − 1)/Re data points falling in a straight line before the “strong inertial effect,” where the data points fall in an approximately horizontal line.
dc.publisherASCE
dc.titleExperimental Study on Nonlinear Flow in Granite Tensile and Shear Fractures
dc.typeJournal Article
dc.journal.volume22
dc.journal.issue12
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0002606
dc.journal.fristpage04022241
dc.journal.lastpage04022241_24
dc.page24
dc.treeInternational Journal of Geomechanics:;2022:;Volume ( 022 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record