• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Energy Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Energy Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Ethanol, Hemp, and Cottonseed Oil Biofuel Injection Completely Eliminates Diesel Fuel in Reactivity-Controlled Compression Ignition Engine

    Thumbnail
    View/Open
    %28ASCE%29EY.1943-7897.0000867.pdf (3.398Mb)
    Date
    2022/12/01
    Author
    Senthamil Selvan Murugan
    Nallusamy Nallusamy
    Prakash Ramasamy
    Venkatesan Vedhagiri
    Metadata
    Show full item record
    Abstract
    The objective of the present work is to investigate the effect of ethanol fraction on combustion, performance, and emission characteristics of a reactivity controlled compression ignition (RCCI) engine fueled with diesel, cottonseed oil methyl ester (CSME), and hemp oil methyl ester (HOME). The low-reactivity fuel ethanol was injected into the intake manifold using a timed manifold injection system controlled by an electronic control unit, whereas the high-reactivity fuel (diesel, CSME, HOME) was directly injected into the combustion chamber at different injection timings to initiate ignition. The injection timing of 23° crank angle (CA) before top dead center (bTDC) promises a flexible combustion phasing and better results in terms of maximum pressure rise, heat release rate, brake thermal efficiency, and emission characteristics using ethanol as a primary fuel. The RCCI mode of operation with a 20% ethanol premixed ratio resulted in increases in brake thermal efficiency by 28.07%, 10.70%, and 12.34% for diesel, CSME, and HOME at part load (50%), respectively, and 13.22%, 3.09%, 5.92% for the same fuels at full load (100%) conditions owing to uniform mixing and better atomization of fuel particles. The specific fuel consumption decreased by 13.79%, 10.34%, and 8.62% for 20E+80Diesel, 20E+80HOME, 20E+80CSME energy ratios, respectively, at part load conditions and 14.29%, 12.50%, and 10.71% at full load conditions versus the conventional combustion mode. The exhaust gas temperature slightly decreased for 50% and 100% load conditions compared with conventional diesel combustion. A reduction of CO2 emissions was observed for 20E+80Diesel, 20E+80HOME, and 20E+80CSME fuel fractions by 2.37%, 2.06%, and 2.85% respectively, at full load condition compared with neat diesel fuel. While increasing the load in all fuel shares, smoke emissions increased slightly. The low-temperature RCCI combustion strategy achieved a reduction of NOx emissions by up to 18.90% at a full load condition for 20E+80HOME fuel fractions.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4289081
    Collections
    • Journal of Energy Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV