Show simple item record

dc.contributor.authorSaleh Ahmadi Soleimani
dc.contributor.authorDimitrios Konstantinidis
dc.contributor.authorGeorgios P. Balomenos
dc.date.accessioned2022-08-18T12:28:06Z
dc.date.available2022-08-18T12:28:06Z
dc.date.issued2022/05/13
dc.identifier.other%28ASCE%29ST.1943-541X.0003365.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4286673
dc.description.abstractDuring the vulcanization process of steel-laminated elastomeric bridge bearings, unavoidable flow of elastomer occurs inside the mold under high pressure and nonuniform heating. This may cause the interior steel laminates to misalign or distort in the finished bearing. There has been limited research to understand and quantify the effects of manufacturing imperfections, such as vertically shifted, rotated, and bent steel laminates, on the mechanical behavior of elastomeric bearings. This paper presents a finite element investigation on the effects of manufacturing imperfections on the performance of elastomeric bridge bearings subjected to service-level loads. It is observed that such imperfections have a negligible effect on the maximum shear strain induced in the elastomer. The strain hardening behavior of the elastomer under relatively large shear strains limits the maximum shear strains to values lower than those predicted by the pressure solution. In one cycle of loading, the vertical deflection of bearings is affected slightly by these imperfections. However, manufacturing imperfections can increase the tensile stresses in the steel laminates causing plastic damage. The spread of plastic damage in the steel laminates with repeated cycling may affect the long-term performance of the bearings.
dc.publisherASCE
dc.titleEffect of Manufacturing Imperfections on the Service-Level Performance of Elastomeric Bridge Bearings
dc.typeJournal Article
dc.journal.volume148
dc.journal.issue7
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0003365
dc.journal.fristpage04022088
dc.journal.lastpage04022088-16
dc.page16
dc.treeJournal of Structural Engineering:;2022:;Volume ( 148 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record