• Login
    View Item 
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Influence of Sample Reconstitution on Advanced Model Calibration

    Thumbnail
    View/Open
    %28ASCE%29GM.1943-5622.0002498.pdf (3.367Mb)
    Date
    2022/05/30
    Author
    Max Oke Kluger
    Majid Goodarzi
    Stefan Kreiter
    Pooyan Ghasemi
    Taisiya Pein
    Tobias Mörz
    Metadata
    Show full item record
    Abstract
    The simulation of granular soil using advanced soil models relies on the precise determination of model parameters from laboratory or field experiments, or both. Although it is well known that sample reconstitution influences the stress–strain response of granular soil, the effect of different reconstitution methods on the calibration of advanced soil models has not been previously comprehensively addressed. In the present study, a hypoplastic model was calibrated from geotechnical laboratory tests on Cuxhaven sand samples. Triaxial tests were performed on samples having been reconstituted by three different methods: moist tamping, vacuum pluviation, and horizontal vibration. The influence of different reconstitution methods on the simulation performance of the hypoplastic model was quantified through three scenarios of increasing complexity: (1) stress–strain behavior in representative element volume (REV), that is, triaxial tests; (2) in situ plate load test (PLT); and (3) laboratory cone penetration test (CPT). The latter two are typical examples of boundary value problems with different strains and stiffnesses. The adopted reconstitution methods significantly affected the REV simulation at high relative density of both peak friction angles and peak dilation angles. The reconstitution methods have a limited effect on boundary value problem simulations, being moderate for PLTs and small for CPTs. The influence of stiffness (intergranular strain) parameters on simulation results increased from REVs (no influence detected), over boundary value problems with low strain and stiffness (PLTs) to boundary value problems with high strain and stiffness (CPTs).
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4286337
    Collections
    • International Journal of Geomechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV