Numerical Modeling of Cone Penetration Test: An LBM–DEM Approach
Date
2022/06/08Author
Krishna Allulakshmi
Jayan S. Vinod
Ana Heitor
Andy Fourie
Metadata
Show full item recordAbstract
In this paper, the discrete element method (DEM) is coupled with the Lattice Boltzmann method (LBM) to model the cone penetration test (CPT) of a saturated granular media. The coupled numerical model was calibrated using one-dimensional (1D) consolidation theory. The results obtained from the 1D consolidation test simulation showed good agreement with the analytical equation that was proposed by Terzaghi. A series of LBM–DEM simulations were carried out to understand the effect of the penetration rate on the behavior of saturated granular materials during the CPT. The model has predicted a significant influence on the excess pore fluid pressure (Δu) and an insignificant influence on the cone resistance responses (qt) and has qualitatively captured the effect of penetration rate, which was consistent with the experimental data. The simulation results showed that Δu increased with an increase in the penetration rate. The particle displacement and fluid velocity (U) contours have provided insights into the particle behavior and fluid pressure fluctuations during CPTs. The increase in Δu was attributed to the fluid pressure gradients that were created by the cone in the fluid system based on the penetration rate. The pore pressure distribution plots have shown a maximum pore fluid pressure below the cone region and over the cone shoulder position. A consistent evolution pattern of fabric anisotropy has been observed throughout the depth (z) under all the penetration rate conditions. The fabric components