| dc.contributor.author | Rajendran, C. | |
| dc.contributor.author | Ben Ruben, R. | |
| dc.contributor.author | Ashokavarthanan, P. | |
| dc.contributor.author | Mallieswaran, K. | |
| dc.date.accessioned | 2022-05-08T09:01:36Z | |
| dc.date.available | 2022-05-08T09:01:36Z | |
| dc.date.copyright | 2/24/2022 12:00:00 AM | |
| dc.date.issued | 2022 | |
| dc.identifier.issn | 2770-3495 | |
| dc.identifier.other | aoje_1_011003.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl1/handle/yetl/4284641 | |
| dc.description.abstract | The corrosion-resistant and strength-to-weight ratios are the primary factors in high-strength aluminum alloy. Hence, the AA2024 alloy is a possible candidate in the critical structural fabrication industry. The traditional joining method is ineffective for welding aluminum alloys. Higher melting point and temperature variations cause alloy isolation | |
| dc.description.abstract | porosity and hot cracking are caused by melting point variations. As a result, to fabricate joints, a light heat source laser beam was used. The weaker area of most fusion-welded joints was the heat-affected zone (HAZ). The post-weld heat treatment was used at HAZ to improve the properties. According to the experimental findings, the joint welded with solution treatment and artificial aging had a maximum tensile strength of 358 MPa. Re-precipitation of precipitates may accomplish in HAZ. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Identifying the Effect of PWHT on Strength of Laser Beam Welding Joints of AA2024 Aluminum Alloy | |
| dc.type | Journal Paper | |
| dc.journal.volume | 1 | |
| dc.journal.title | ASME Open Journal of Engineering | |
| dc.identifier.doi | 10.1115/1.4053496 | |
| dc.journal.fristpage | 11003-1 | |
| dc.journal.lastpage | 11003-8 | |
| dc.page | 8 | |
| dc.tree | ASME Open Journal of Engineering:;2022:;volume( 001 ) | |
| dc.contenttype | Fulltext | |
