Erratum: “Scaling Roughness Effects on Pressure Loss and Heat Transfer of Additively Manufactured Channels” [J. Turbomach. 139(2), p. 021003
DOI: 10.1115/1.4034555]
| dc.contributor.author | Stimpson, Curtis K. | |
| dc.contributor.author | Snyder, Jacob C. | |
| dc.contributor.author | Thole, Karen A. | |
| dc.contributor.author | Mongillo, Dominic | |
| dc.date.accessioned | 2022-05-08T08:55:05Z | |
| dc.date.available | 2022-05-08T08:55:05Z | |
| dc.date.copyright | 2/17/2022 12:00:00 AM | |
| dc.date.issued | 2022 | |
| dc.identifier.issn | 0889-504X | |
| dc.identifier.other | turbo_144_4_047001.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl1/handle/yetl/4284505 | |
| dc.description.abstract | There is an error in the original paper in the description of the applicability range for Eq. (9) that could misguide the reader. The valid range of Eq. (9) is Ra/Dh > | |
| dc.description.abstract | 0.0028.On page 8, in the paragraph following Eq. (9), the statements on the applicability of the correlation should read:“This correlation is only valid for Ra/Dh > | |
| dc.description.abstract | 0.0028 as values below this threshold result in a negative ks/Dh. Relative equivalent sand grain roughness should be assumed to equal zero for Ra/Dh < | |
| dc.description.abstract | 0.0028.” | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Erratum: “Scaling Roughness Effects on Pressure Loss and Heat Transfer of Additively Manufactured Channels” [J. Turbomach. 139(2), p. 021003 | |
| dc.title | DOI: 10.1115/1.4034555] | |
| dc.type | Journal Paper | |
| dc.journal.volume | 144 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Turbomachinery | |
| dc.identifier.doi | 10.1115/1.4042129 | |
| dc.journal.fristpage | 47001-1 | |
| dc.journal.lastpage | 47001-1 | |
| dc.page | 1 | |
| dc.tree | Journal of Turbomachinery:;2022:;volume( 144 ):;issue: 004 | |
| dc.contenttype | Fulltext |