Show simple item record

dc.contributor.authorT. Joyce
dc.contributor.authorY. H. Chui
dc.date.accessioned2022-05-07T20:24:48Z
dc.date.available2022-05-07T20:24:48Z
dc.date.issued2022-01-07
dc.identifier.other(ASCE)ST.1943-541X.0003261.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4282395
dc.description.abstractUnder the load and resistance factor design philosophy used in North America, building codes structures are designed using load and resistance factors calibrated to a target reliability level. Despite this, few attempts have been made to calibrate resistance factors for timber connections. A calibration process was carried out for the withdrawal resistance of axially loaded self-tapping screws using a database of test results from across Canada. Two load cases were considered, reflecting load combinations and statistics drawn from the 2015 National Building Code of Canada and from a proposal developed to provide greater consistency in reliability outcomes, and the reliability under each case was determined using the first-order reliability method (FORM). Given the low ductility–brittle nature of withdrawal failures, a resistance factor of φ=0.7 was recommended for a target reliability index of β=4.0. The outcomes will assist in the selection of a resistance factor for self-tapping screws for use in the Canadian timber design standard, CSA O86.
dc.publisherASCE
dc.titleCalibration of Resistance Factor for Self-Tapping Screws in Canada
dc.typeJournal Paper
dc.journal.volume148
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0003261
dc.journal.fristpage04022001
dc.journal.lastpage04022001-7
dc.page7
dc.treeJournal of Structural Engineering:;2022:;Volume ( 148 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record