Show simple item record

dc.contributor.authorKrishanu Roy
dc.contributor.authorBoshan Chen
dc.contributor.authorZhiyuan Fang
dc.contributor.authorAsraf Uzzaman
dc.contributor.authorJames B. P. Lim
dc.date.accessioned2022-05-07T20:23:56Z
dc.date.available2022-05-07T20:23:56Z
dc.date.issued2021-11-24
dc.identifier.other(ASCE)ST.1943-541X.0003238.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4282374
dc.description.abstractAn experimental investigation of 12 screw-fastened back-to-back built-up aluminum alloy slender columns under axial compression is presented, complemented by a numerical finite element study comprising 246 results. Using a laser scanner, the geometric imperfections were measured. In the numerical study, the effect of the modified slenderness, number of screws, and section thickness were investigated. Axial strengths obtained from the tests and finite element (FE) were used to assess guidance given in the Aluminum Design Manual (ADM 2020), Eurocode9 (CEN 2007), Australian/New Zealand Standards (AS/NZS 2018), and American Iron and Steel Institute (AISI 2016) standards. The ADM 2020 and CEN 2007 were found to be conservative by 30%. However, AISI 2016 and AS/NZS 2018 were found to be more accurate relative to the test and FE analysis results and shown to be conservative by 5%.
dc.publisherASCE
dc.titleAxial Capacity of Back-to-Back Built-Up Aluminum Alloy Channel Section Columns
dc.typeJournal Paper
dc.journal.volume148
dc.journal.issue2
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0003238
dc.journal.fristpage04021265
dc.journal.lastpage04021265-24
dc.page24
dc.treeJournal of Structural Engineering:;2021:;Volume ( 148 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record