Show simple item record

dc.contributor.authorSaleh Ahmadi Soleimani
dc.contributor.authorDimitrios Konstantinidis
dc.contributor.authorGeorgios P. Balomenos
dc.date.accessioned2022-05-07T20:22:20Z
dc.date.available2022-05-07T20:22:20Z
dc.date.issued2021-10-21
dc.identifier.other(ASCE)ST.1943-541X.0003200.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4282336
dc.description.abstractElastomeric bridge bearings are installed between the bridge superstructure and substructure to accommodate translational and rotational deformations. The manufacturing quality of elastomeric bridge bearings is of high significance because manufacturing defects (such as variations in rubber layer thickness and nonparallel steel laminates) may jeopardize their short- and long-term structural behavior and integrity. Current quality control procedures involve destructive testing of samples of bearings from a lot. This type of testing is time consuming and costly, and thus limited to a relatively small sample size, which may undermine confidence in the quality of remaining bearings in the lot. This paper presents an alternative, vision-based assessment methodology for the nondestructive identification of the internal structure of elastomeric bridge bearings. The methodology capitalizes on the high deformability of rubber and the near inextensibility of the steel laminates, which together result in a unique deformation pattern on the vertical surfaces of a bearing when it is subjected to axial load. This deformation pattern features local extrema in in-plane strain and horizontal displacement fields on the vertical surfaces. These local extrema are analyzed to deduce the thicknesses of the rubber layers and rubber side covers. The methodology is developed based on three-dimensional finite-element analyses (3D-FEA). Then, three-dimensional digital image correlation (3D-DIC) is used in experimental tests to evaluate its capability to identify manufacturing defects in elastomeric bridge bearings. Finally, the methodology is validated against destructive tests. The nondestructive method presented in this study is conducted in conjunction with compressive tests that departments of transportation carry out routinely and is therefore expected to facilitate rapid and cost-effective qualification of elastomeric bridge bearings.
dc.publisherASCE
dc.titleNondestructive Assessment of Elastomeric Bridge Bearings Using 3D Digital Image Correlation
dc.typeJournal Paper
dc.journal.volume148
dc.journal.issue1
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0003200
dc.journal.fristpage04021233
dc.journal.lastpage04021233-15
dc.page15
dc.treeJournal of Structural Engineering:;2021:;Volume ( 148 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record