Show simple item record

dc.contributor.authorWang, Ruiyang
dc.contributor.authorYang, Bingen
dc.contributor.authorGao, Hao
dc.date.accessioned2022-02-06T05:26:29Z
dc.date.available2022-02-06T05:26:29Z
dc.date.copyright3/19/2021 12:00:00 AM
dc.date.issued2021
dc.identifier.issn0022-0434
dc.identifier.otherds_143_08_081003.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4278028
dc.description.abstractAs a new strategy for magnetic levitation envisioned in the 1990s, the Inductrack system with Halbach arrays of permanent magnets has been intensively researched. The previous investigations discovered that an uncontrolled Inductrack system may be unstable even if the vehicle travels well below its operating speed and that instability can be persistent near and beyond the operating speed. It is therefore necessary to stabilize the system for safety and reliability. With strong nonlinearities and complicated electromagneto-mechanical coupling, however, the transient response of such a dynamic system is difficult to predict with fidelity. Because of this, model-based feedback control of Inductrack systems has not been well addressed. In this paper, by taking advantage of a recently available two degrees-of-freedom transient model, a new feedback control method for Inductrack systems is proposed. In the control system development, active Halbach arrays are used as an actuator, and a feedback control law, which combines a properly tuned proportional-integral-derivative controller and a nonlinear force-current mapping function, is created. The proposed control law is validated in numerical examples, where the transient motion of an Inductrack vehicle traveling at constant speeds is considered. As shown in the simulation, the control law efficiently stabilizes the Inductrack system in a wide range of operating speed, and in the meantime, it renders a smooth system output (real-time levitation gap) with fast convergence to any prescribed reference step input (desired levitation gap).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNonlinear Feedback Control of the Inductrack System Based on a Transient Model
dc.typeJournal Paper
dc.journal.volume143
dc.journal.issue8
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4050257
dc.journal.fristpage081003-1
dc.journal.lastpage081003-13
dc.page13
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2021:;volume( 143 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record