Show simple item record

dc.contributor.authorAit Ladel, Ayyoub
dc.contributor.authorBenzaouia, Abdellah
dc.contributor.authorOutbib, Rachid
dc.contributor.authorOuladsine, Mustapha
dc.date.accessioned2022-02-06T05:26:25Z
dc.date.available2022-02-06T05:26:25Z
dc.date.copyright3/19/2021 12:00:00 AM
dc.date.issued2021
dc.identifier.issn0022-0434
dc.identifier.otherds_143_08_081001.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4278026
dc.description.abstractThis article addresses the simultaneous fault detection and control (SFDC) issue for switched Takagi–Sugeno (T–S) fuzzy systems with state jumps. The main objective is to design robust detection filters and observer-based controllers to stabilize this system class and, at the same time, detect the presence of faults. Less conservative stability conditions are developed, applying the mode-dependent average dwell time (MDADT) concept, the robust H∞ approach, and the piecewise Lyapunov function (PLF) technique. Based on these conditions, the integrated controller and detector design is formalized in the form of linear matrix inequalities (LMI) instead of bilinear matrix inequalities (BMI). The proposed LMIs determine the controller/detector gains simultaneously in a single step, thus offering more degrees-of-freedom in the design. Finally, a numerical example and two real systems are studied to prove the applicability and effectiveness of the obtained results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimultaneous Fault Detection and Control for Continuous-Time Switched Takagi–Sugeno Fuzzy Systems With State Jumps
dc.typeJournal Paper
dc.journal.volume143
dc.journal.issue8
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4050254
dc.journal.fristpage081001-1
dc.journal.lastpage081001-11
dc.page11
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2021:;volume( 143 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record