Effect of Fuel Injection Pressure and Premixed Ratio on Mineral Diesel-Methanol Fueled Reactivity Controlled Compression Ignition Mode Combustion Engine

Abstract

Reactivity controlled compression ignition (RCCI) mode combustion has attracted significant attention because of its superior engine performance and significantly lower emissions of oxides of nitrogen (NOx) and particulate matter (PM) compared with conventional compression ignition (CI) mode combustion engines. In this experimental study, effects of fuel injection pressure (FIP) of high reactivity fuel (HRF) and premixed ratio of low reactivity fuel (LRF) were evaluated on a diesel-methanol fueled RCCI mode combustion engine. Experiments were performed in a single cylinder research engine at a constant engine speed (1500 rpm) and constant engine load (3 bar BMEP) using three different FIPs (500, 750, and 1000 bar) of mineral diesel and four different premixed ratios (rp = 0, 0.25, 0.50, and 0.75) of methanol. Results showed that RCCI mode resulted in more stable combustion compared with baseline CI mode combustion. Increasing FIP resulted in relatively higher knocking, but it reduced with increasing premixed ratio. Relatively higher brake thermal efficiency (BTE) of RCCI mode combustion compared with baseline CI mode combustion is an important finding of this study. BTE increased with increasing FIP of mineral diesel and increasing premixed ratio of methanol. Relatively dominant effect of increasing FIP on BTE at higher premixed ratios of methanol was also an important finding of this study. RCCI mode combustion resulted in higher carbon monoxide (CO) and hydrocarbon (HC) emissions, but lower PM and NOx emissions compared with baseline CI mode combustion. Increasing FIP of HRF at lower premixed ratios reduced the number concentration of particles; however, effect of FIP became less dominant at higher premixed ratios. Relatively higher number emissions of nanoparticles at higher FIPs were observed. Statistical and qualitative correlations exhibited the importance of suitable FIP at different premixed ratios of LRF on emission characteristics of RCCI mode combustion engine.