Show simple item record

dc.contributor.authorTao Li
dc.contributor.authorMingjing Jiang
dc.contributor.authorLiqing Li
dc.date.accessioned2022-02-01T21:54:05Z
dc.date.available2022-02-01T21:54:05Z
dc.date.issued10/1/2021
dc.identifier.other%28ASCE%29GM.1943-5622.0002177.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4272254
dc.description.abstractThe three-dimensional discrete element method (DEM) is employed to investigate the macro- and microscopic mechanical behaviors of unsaturated silt subjected to one-dimensional (K0) and constant stress ratio loadings. A DEM sample was prepared by installing a contact model considering rolling and twisting resistances and the van der Waals force. Capillary forces were installed at contacts to represent the unfilled water effect. Strain-controlled one-dimensional and constant stress ratio compression tests were then simulated on the specimens with different constant matric suctions and stress ratios (η = q/p). The discrete element simulation results reproduce the primary macroscopic mechanical behavior observed in laboratory tests. Shear failure occurs in specimens compressed under stress ratios exceeding the strength slope M, while volumetric yielding occurs in specimens compressed under very small stress ratios η ≪ M. The compression test under a constant stress ratio larger than M reaches the critical state characterized by not only a constant stress state and void ratio, but also a constant effective particle number, (mechanical) an average coordination number, and fabric anisotropies of contact normals and contact forces. The contribution of normal contact forces to the deviator stress predominates over tangential contact forces throughout the simulation. The capillary stress (capillary force-induced stress tensor) anisotropy decreases under isotropic compression but increases under anisotropic compression (η = 1.25). The mechanical average coordination number versus mean stress is independent of the stress ratio and the matric suction. Fabric evolutions indicate that the rearrangement of contact forces is much quicker than that of contact normals at the beginning of compression.
dc.publisherASCE
dc.titleDEM Analysis of Mechanical Behavior of Unsaturated Silt under Strain-Controlled Constant Stress Ratio Compression Tests
dc.typeJournal Paper
dc.journal.volume21
dc.journal.issue10
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0002177
dc.journal.fristpage04021197-1
dc.journal.lastpage04021197-10
dc.page10
dc.treeInternational Journal of Geomechanics:;2021:;Volume ( 021 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record