Show simple item record

dc.contributor.authorJin Wang
dc.contributor.authorGregory A. Kopp
dc.date.accessioned2022-01-31T23:45:23Z
dc.date.available2022-01-31T23:45:23Z
dc.date.issued3/1/2021
dc.identifier.other%28ASCE%29ST.1943-541X.0002922.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4270299
dc.description.abstractThe purpose of this study is to investigate the effects of building geometry on tall-building aerodynamics, accompanying the analysis for low-rise buildings found in the companion paper. Aerodynamic data for total of 30 rectangular-plan buildings were obtained in wind tunnel experiments. This work tested building configurations with plan aspect ratios, L/B (where L is the horizontal dimension parallel to the wind and B is the across-wind dimension) ranging from 0.25 to 4 and height ratios, H/W (where H is roof height and W is the least horizontal dimension) ranging from 1 to 12. Additionally, this work made systematical comparisons with wind load provisions in Chapter 27 of ASCE 7-16. Buildings with ratios of H/W>∼4 have aerodynamic coefficients that are approximately constant, which means that this can be a practical aerodynamic definition of high-rise buildings. There is continuous variation of the aerodynamic coefficients for H/W<4 such that differentiation of mid-rise and low-rise buildings may be considered as arbitrary from an aerodynamics perspective. Wind load coefficients for mid-rise buildings are observed to be lower than for high-rise buildings. However, for both mid-rise and high-rise buildings, largest load coefficients are observed for L/B∼0.67. The plan ratio of L/B captures the variation of the load coefficients for high-rise buildings. For lower buildings, both L/B and H/W ratios are needed to define the wind loads.
dc.publisherASCE
dc.titleComparisons of Aerodynamic Data with the Main Wind Force–Resisting System Provisions of ASCE 7-16. II: Mid- and High-Rise Buildings
dc.typeJournal Paper
dc.journal.volume147
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002922
dc.journal.fristpage04020348-1
dc.journal.lastpage04020348-18
dc.page18
dc.treeJournal of Structural Engineering:;2021:;Volume ( 147 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record