Show simple item record

dc.contributor.authorBo Yang
dc.contributor.authorMinhao Dong
dc.contributor.authorQi Han
dc.contributor.authorMohamed Elchalakani
dc.contributor.authorGang Xiong
dc.date.accessioned2022-01-30T22:45:51Z
dc.date.available2022-01-30T22:45:51Z
dc.date.issued2/1/2021
dc.identifier.other(ASCE)ST.1943-541X.0002871.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4269553
dc.description.abstractIn this study, the flexural behavior and rotation capacity of welded I-beams made from 690-MPa high-strength steel were investigated through experimental tests and numerical simulations. In the experimental program, a total of 16 beams with different width-to-thickness ratios and spans were tested to failure under three- and four-point bending. The flexural strength and rotation capacity were studied in the test. Finite-element models with initial geometric imperfections and residual stresses were established and verified by the test results. A series of parametric studies on flange and web slenderness was conducted based on the verified numerical model. Comparisons were made between test results, numerical results, and design calculations obtained from three international design standards to investigate the applicability of the current design methods to high-strength (690-MPa) steel I-beams.
dc.publisherASCE
dc.titleFlexural Behavior and Rotation Capacity of Welded I-Beams Made from 690-MPa High-Strength Steel
dc.typeJournal Paper
dc.journal.volume147
dc.journal.issue2
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002871
dc.journal.fristpage04020320
dc.journal.lastpage04020320-16
dc.page16
dc.treeJournal of Structural Engineering:;2021:;Volume ( 147 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record