Show simple item record

dc.contributor.authorJiuqun Zou
dc.contributor.authorJihuan Han
dc.contributor.authorTao Zhang
dc.contributor.authorWeihao Yang
dc.date.accessioned2022-01-30T21:48:01Z
dc.date.available2022-01-30T21:48:01Z
dc.date.issued12/1/2020 12:00:00 AM
dc.identifier.other%28ASCE%29GM.1943-5622.0001869.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4268859
dc.description.abstractThe effects of initial stress conditions and rock breaking parameters on rock fragmentation were investigated through indentation tests and numerical analysis with a discrete element method (DEM). Different initial stress conditions and the thrusting velocity of the cutter were the focus in the design of indentation tests. Some indicators were used to reflect the instability of the thrusting force, rock breaking efficiency, failure patterns, and the fluctuation of force-penetration response. The indentation results show that rock failure patterns have a closed correlation with initial stress conditions and loading rate. All tests showed several distinct chipping phases, and obvious chiseled pit and crushed rock could be observed on the top surface of each rock specimen. Moreover, rock brittleness was evaluated by the fluctuation of force-penetration curves; this study also revealed the changing law of peak and mean thrusting force. In addition, the numerical simulation of indentation tests reproduced the development process of rock fragmentation and crack propagation. Increasing confining stress restrained the propagation of vertical and lateral cracks, whereas the axial stress had the effect of restraining the propagation of radial cracks. However, there is a critical confining stress that causes different results of fractured depth. Therefore, this investigation is beneficial for optimizing the cutting parameters to promote rock breaking efficiency.
dc.publisherASCE
dc.titleExperimental Investigation and Numerical Analyses for Red Sandstone Rock Fragmentation
dc.typeJournal Paper
dc.journal.volume20
dc.journal.issue12
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0001869
dc.page13
dc.treeInternational Journal of Geomechanics:;2020:;Volume ( 020 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record