Show simple item record

dc.contributor.authorRodolfo Álvarez
dc.contributor.authorJosé I. Restrepo
dc.contributor.authorMarios Panagiotou
dc.date.accessioned2022-01-30T21:09:16Z
dc.date.available2022-01-30T21:09:16Z
dc.date.issued12/1/2020 12:00:00 AM
dc.identifier.other%28ASCE%29ST.1943-541X.0002836.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4267738
dc.description.abstractThe beam-truss model (BTM), developed for the nonlinear cyclic analysis of reinforced concrete components including softening, is extended to compute the out-of-plane buckling observed in plastic hinges of various slender structural walls. This is achieved by using fiber-section displacement-based elements with PDelta geometric transformation and diagonal truss-elements with Corotational transformation. The BTM is enhanced by considering strain penetration at the base of the walls. This paper discusses the BTM for three test specimens that exhibited out-of-plane buckling and whose response softened as a result of this phenomenon. The test specimens’ unsupported height-to-wall thickness ratio ranged between 10 and 25. Using the same calibration of the modeling parameters for the development of the three models, the BTM is validated by comparing measured and computed lateral force−displacement responses, out-of-plane displacements, and local strain responses. The BTM accurately computes the force−displacement responses as well as out-of-plane displacements of the test specimens and the buckling behavior.
dc.publisherASCE
dc.titleRC Wall Plastic Hinge Out-of-Plane Buckling: Analysis Using the Nonlinear Beam-Truss Model
dc.typeJournal Paper
dc.journal.volume146
dc.journal.issue12
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002836
dc.page20
dc.treeJournal of Structural Engineering:;2020:;Volume ( 146 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record