Show simple item record

dc.contributor.authorPengjun Luo
dc.contributor.authorHayato Asada
dc.contributor.authorChia-Ming Uang
dc.contributor.authorTsuyoshi Tanaka
dc.date.accessioned2022-01-30T20:09:31Z
dc.date.available2022-01-30T20:09:31Z
dc.date.issued2020
dc.identifier.other%28ASCE%29ST.1943-541X.0002580.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4266613
dc.description.abstractPartial-joint-penetration (PJP) groove weld is commonly used as an alternative to fillet weld when high-strength joints are needed. The majority of previous research on the effect of loading angle on the weld strength focuses on fillet welds, but not PJP welds. Both US specifications and Japan recommendations use a directional strength increase factor to determine the strength of fillet welds. However, these factors do not apply to PJP welds; also, US specifications, Japan recommendations, and European standards give different design criteria for PJP welds loaded with 90°. This paper presents results from a study that investigated the mechanical behavior of PJP welds under different loading angles. Results obtained from both finite-element analysis and experiments indicate that current US design practice is conservative when the directionality effect is ignored in calculating the strength of PJP welds.
dc.publisherASCE
dc.titleDirectionality Effect on Strength of Partial-Joint-Penetration Groove Weld Joints
dc.typeJournal Paper
dc.journal.volume146
dc.journal.issue4
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002580
dc.page04020030
dc.treeJournal of Structural Engineering:;2020:;Volume ( 146 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record