• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Shear-Out Capacity of Bolted Connections in Cold-Reduced Steel Sheets

    Thumbnail
    View/Open
    %28ASCE%29ST.1943-541X.0002565.pdf (1.127Mb)
    Date
    2020
    Author
    Haoyu Xing
    Lip H. Teh
    Zhengyi Jiang
    Aziz Ahmed
    Metadata
    Show full item record
    Abstract
    This study examined the accuracy of design equations specified in the North American, European, and Australian/New Zealand standards for determining the shear-out capacity of bolted connections in cold-reduced steel sheets. The tested variables were end distance, bolt (hole) diameter, sheet thickness, edge distance, and material properties. The paper showed that the catenary action in a narrow strip downstream of the bolt has a significant effect on the shear-out capacity, and is not accounted for in the design codes. The contribution of catenary action was corroborated with finite-element analysis results. The paper also showed that the edge distance of a bolted connection has insignificant effects on the shear-out capacity, although it affects the failure mode. An additional finding is that shearing (rather than sawing) the end of a cold-reduced steel sheet sometimes can change the failure mode into end splitting, but not to the same extent as in hot-rolled steel plates. Based on the test results of 60 single-bolted specimens with end distances ranging from 1.25 to 3.0 times the bolt diameter, this paper derived a shear-out equation that is dimensionally consistent, continuous, and transparent, and that is much more accurate than the code equations. The proposed equation, which includes the bolt diameter as a parameter, was verified against independent test specimens with end distances as small as 1.0 times the bolt diameter. A resistance factor of 0.70 is recommended for use with the proposed equation for determining the shear-out capacity of bolted connections in cold-reduced steel sheets.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4266598
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV