Show simple item record

dc.contributor.authorVemuri V. Rangarao
dc.contributor.authorKolluru V. L. Subramaniam
dc.contributor.authorS. Suriya Prakash
dc.date.accessioned2022-01-30T20:06:20Z
dc.date.available2022-01-30T20:06:20Z
dc.date.issued2020
dc.identifier.other%28ASCE%29ST.1943-541X.0002500.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4266527
dc.description.abstractIn this study, the buckling-resistant antispring-clad reinforcing bar (BRASR) for improving the performance of the longitudinal reinforcing bars embedded in concrete columns is presented. BRASR is formed using a set of springs wound in opposing directions and clad on the rebar with a groutable gap. In an experimental program, the performance of the BRASR is compared with the conventional longitudinal rebar in a typical column reinforcement cage. Short reinforced concrete (RC) square column elements with parametric variations in the ratio of tie spacing to the diameter of longitudinal bar (s/d) and the influence of tie restraint are evaluated under applied uniaxial compression. RC columns with spring clad bars exhibited improved buckling resistance of the rebar, which enhances the load capacity and the ultimate displacement ductility. In columns with BRASR, there is an increase in the strain energy and the resistance of the concrete core is improved. While the conventional specimens failed by a decrease in load resistance, the BRASR specimens showed better post-peak behavior and ductility.
dc.publisherASCE
dc.titleBehavior of Short Reinforced Concrete Column Elements with Buckling-Resistant Antispring-Clad Reinforcing Bars (BRASR) under Axial Compression
dc.typeJournal Paper
dc.journal.volume146
dc.journal.issue2
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002500
dc.page04019203
dc.treeJournal of Structural Engineering:;2020:;Volume ( 146 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record